Filter
Top Products
Service Information
P6434 Probe Instructions
29
To reassemble the module end of the probe, follow these steps:
1. If you are installing either the pin 1 or pin 38 cable kit, follow the procedure
to reassemble the probe tip.
2. On the module end, position the trim pieces in the connector housing as
shown in Figure 24.
Trim piece
Connector key
Figure 24: Reassembling the module end
3. Orient the nonkeyed side of the connector to the case half with the label, and
position the connector in the case halves.
4. Attach the case halves and reconnect the screws as shown in Figure 24.
5. You may need to reapply labels. Refer to the description of Labels on page 2
for information on how to apply labels.
Module End