Filter
Top Products
Power and PowerUp Modes
TOSHIBA A40 Series 610
TOSHIBA A40 Series Version
1
Last Saved on 02/12/2003 17:24
ENGLISH using Euro_M.dot –– Printed on 02/12/2003 as IM_A40EN
Monitoring battery capacity
Remaining battery power can be monitored in Power Saver.
Wait at least 16 seconds after turning on the computer before trying to
monitor the remaining operating time. The computer needs this time to
check the battery’s remaining capacity and to calculate the remaining
operating time, based on the current power consumption rate and
remaining battery capacity. The actual remaining operating time may differ
slightly from the calculated time.
With repeated discharges and recharges, the battery’s capacity will
gradually decrease. Therefore, an often used, older battery will not
operate for as long as a new battery even when both are fully charged. In
this case, TOSHIBA Power Saver will indicate a 100% charge for both the
old and new battery, but the displayed estimated time remaining will be
shorter for the older battery.
Maximising battery operating time
A battery’s usefulness depends on how long it can supply power on a
single charge.
How long the charge lasts in a battery depends on:
■ How you configure the computer, for example, whether you enable
batterypower saving options. The computer provides a battery save
mode, which can be set in TOSHIBA Power Saver, to conserve
battery power. This mode has the following options:
■ CPU Processing speed
■ Screen brightness
■ System standby
■ System Hibernation
■ Monitor Power off
■ HDD Power off
■ How often and how long you use the hard disk and the diskette drive.
■ How much charge the battery contained to begin with.
■ How you use optional devices, such as a PC card, to which the
battery supplies power.
■ Enabling Standby mode conserves battery power if you are frequently
turning the computer off and on.
■ Where you store your programs and data.
■ Closing the display when you are not using the keyboard saves
power.
■ Operating time decreases at low temperatures.
■ The condition of the battery terminals. Make sure the battery terminals
stay clean by wiping them with a clean dry cloth before installing the
battery pack.