Filter
Top Products
Display Controller and Modes
TOSHIBA A40 Series D8
TOSHIBA A40 Series Version
1
Last Saved on 02/12/2003 17:24
ENGLISH using Euro_M.dot –– Printed on 02/12/2003 as IM_A40EN
4. The DVD video overlay is not displayed when the display mode of
CRT display is set to high resolution and high refresh rate mode at
LCD/CRT simultaneous or multimonitor.
Please decrease the resolution and refresh rate of CRT display.
5. A DVDreproduced image may not be displayed in correct position
when you press Fn+F1 to enter into Instant Security mode while a
DVD is playing under WinDVD 4.0, and then move the mouse or press
the key to exit Instant Security mode. In this case, close WinDVD 4.0
and open it again, or pres the Stop button and then the Play button to
display the DVD image in correct position.
The following steps will work around this problem.
a. Run WinDVD 4.0. Click the Subpanel button and select the Display
option from the list.
b. In the Subpanel window, click the Setup button.
c. In the Setup window, deselect the Hardware decode acceleration
checkbox (Deselecting this checkbox will automatically deselect the
Hardware colour acceleration checkbox).
d. Click the OK button (The Setup tab panel will close).