Filter
Top Products
Optional Devices
TOSHIBA A40 Series 88
TOSHIBA A40 Series Version
1
Last Saved on 02/12/2003 17:24
ENGLISH using Euro_M.dot –– Printed on 02/12/2003 as IM_A40EN
9. Insert a new module in the socket and push it down so it lies flat and
is secured by two latches on either side.
Installing the memory module.
10. Seat the insulation sheet to cover the module.
Be sure to check that the insulation sheet is returned to the original
position to cover the memory module.
11. Insert tabs on the front of the keyboard into corresponding notches on
the computer and seat the keyboard.
When seating the keyboard, be sure to fit the flexible printed circuit board
under the palm rest if the flat cable was pulled out while you were
removing the keyboard.
12. Two screws secure the keyboard and one screw secures the metal
brace.
Be sure to use all two screws removed in step 6. Make sure no screw was
dropped into the computer. Make sure all foreign matter, such as the tape
applied in step 9 is removed.
13. Seat the keyboard brace and press to secure latches.
14. Install the battery pack. Refer to Replacing the battery pack section in
Chapter 6, Power and Powerup Modes, for details.
15. Turn the power on and make sure the added memory is recognized.
Open System Properties in the Control Panel and click the General
tab.