Filter
Top Products
- 124 -
Transmissive sensor (when using preprinted labels):
Feeding takes place according to the parameter designated by the Label Size
Set Command. However, the label-to-label gap is automatically sensed by the
transmissive sensor and the stop position is finely adjusted according to the
value set by the threshold set operation (key operation).
Reflective sensor (when using a manual threshold value)
Feeding takes place according to the parameters designated by the Label Size
Set Command. However, the black mark provided on the back of the tag
paper is automatically sensed by the reflective sensor and the paper position is
finely adjusted for every piece, according to the value set by the threshold set
operation (key operation).
(2) Cut/non-cut
This option is valid in batch feed mode only. (Non-cut is selected in strip mode.)
If no subsequent command is received from the PC for 3 seconds after cut-feeding
when “with automatic forward feed standby” is set in the system mode, the printer
automatically performs a 10-mm forward feed.
When the Feed Command is received in the forward feed standby state, the
printer performs a reverse feed to the original position.
* For notes, refer to the section regarding the Issue Command.
For cutting the label having label pitch of 38 mm or less, refer to the section
regarding the Position Fine Adjustment Command.
(3) Feed mode
[C: Batch (Non-cut)]
[C: Batch (Cut)]
“Without automatic forward feed standby” selected in the system mode.
Head position
(1) Place paper.
(2) End of feed
(Completes feeding to the top of form and stops)
(2) End of feed (Completes feeding to the top of form)
Head position
Cut position
(1) Place paper.
(3) Feeds to the cut position.
(4) Cuts unnecessary paper.
(5) Feeds back to the home position.