Filter
Top Products
- 15 -
NOTES:
1. If a command is not recognized as a command, it is ignored.
e.g.) [ESC] H, [ESC]AA, and so on.
2. If the number of digits of the parameter is specified, when the number of in put digits does not
match the specified number of digits, a command error occurs.
3. When a parameter is set to any character/value other than specified characters/values, a
command error occurs.
e.g.) In the case that a value should be set for parameter, “0001” is acceptable, however, “000A”
results in an error.
In the case that a character should be set for parameter, “A” is acceptable, however, “1” results in
an error.
4. If the value range of the parameter is specified, when any value beyond the range is entered, a
command error occurs. (Except for the D command)
5. When a parameter is missing, which cannot be omitted, a command error occurs.
6. The parameter should be set to either a value or a character, even if the parameter is defined as
“Ignore”.
e.g.) a : Ignore
If it is omitted, a command error occurs, except when the parameter is omissible.
If the number of digits of the parameter is specified, when the number of input digits does not
match the specified number of digits, a command error occurs.
7. When any value/character other than available values/characters for the parameter function is set,
a command error occurs.
e.g.) Parameter “e” for the LC command.
e: Type of line
0: Line
1: Rectangle
If “2” is set to parameter “e”, a command error occurs.
8. About D command
1) Parameter “aaaa”, “bbbb” and “cccc”
When any value lager than maximum value is entered for these three parameters, the entered
value is internally changed to the maximum value.
When any value smaller than minimum value is entered for these tree parameters, the entered
value is internally changed to the minimum value.
2) When “aaaa” is smaller than “cccc”, a command error occurs.
3) When “aaaa – cccc < 2mm”, it is internally changed to “cccc = aaaa – 2mm”.