Filter
Top Products
- 164 -
C: Stored PC command save file
SOH STX “C” Slot
Stored PC command save file name
ETX EOT CR LF
01H 02H 43H xxH
File name 1 00H File name 2 00H ··· File name n 00H
03H 04H 0DH 0AH
In the following cases, 1 byte of “00H” is returned as the stored PC command save
file name.
There is no file.
The memory board is not inserted in the specified slot.
D: Stored True Type Font file
SOH STX “D” Slot
Stored PC command save file name
ETX EOT CR LF
01H 02H 43H xxH
File name 1 00H File name 2 00H ··· File name n 00H
03H 04H 0DH 0AH
In the following cases, 1 byte of “00H” is returned as the stored True Type Font file
name.
There is no file.
The memory board is not inserted in the specified slot.
(2) This command is one of the types of commands that is processed as it is received.
Processing takes place starting from the ones received first. Until the process of
the command previously sent is completed, this command is not processed.
Therefore, if the printer is not in the idle state when this command is sent, the
program version data may not be returned immediately.
Note (1) This command is effective only for the serial interface (RS-232C).
This command is not supported for a parallel interface (Centronics), since
transmission cannot be performed in the parallel interface.
File name (including expansion):
“00H” should be placed between file
names.
Slot:
“1” (31H): Slot 1
File name (including expansion):
“00H” should be placed between file
names.
Slot:
“1” (31H): Slot 1