Filter
Top Products
- 170 -
6.4.2 FINE ADJUSTMENT VALUE SET COMMAND [ESC] Z2; 2
Function Sets various fine adjustment values on the printer.
Format [ESC] Z2; 2, abbbcdddeffghhhijjkllmnnoppqqrr [LF] [NUL]
Term a: Indicates the direction, forward or backward, in which a feed length fine
adjustment is to be made.
+: Ignore
-: Ignore
bbb: Feed length fine adjustment value
Ignore
c: Indicates the direction, forward or backward, in which a cut position (or strip
position) fine adjustment is to be made.
+: Ignore
-: Ignore
ddd: Fine adjustment value for the cut position (or strip position)
Ignore
e: Indicates whether the back feed is to be increased or decreased.
+: Ignore
-: Ignore
ff: Back feed length fine adjustment value
Ignore
g: Indicates the direction, positive or negative, in which the X-coordinate fine
adjustment is to be made.
+: Positive direction
-: Negative direction
hhh: X-coordinate fine adjustment value
000 to 995 (in units of 0.5 mm)
*1
i: Indicates whether to increase or decrease the density in the thermal transfer print
mode.
+: Ignore
-: Ignore
jj: Print density fine adjustment value (for the thermal transfer print mode)
Ignore
k: Indicates whether to increase or decrease the density in the direct thermal print
mode.
+: Ignore
-: Ignore
ll: Print density fine adjustment value (for the direct thermal print mode)
Ignore
m: Fine adjustment direction for the ribbon rewind motor voltage
-: Ignore
nn: Fine adjustment value for the ribbon rewind motor voltage
Ignore