Filter
Top Products
1
2
3
4
5
6
7
9
10
11
12
8
8
4. PRECAUTIONS
1. Installation
The e-STUDIO should be placed near an outlet that is easily accessible.
1
The e-STUDIO16/20/25 should be installed by an authorized TOSHIBA service technician.
Note
The packing material should be disposed of properly.
3
After a suitable place has been selected for installation of the e-STUDIO16/20/25, please
avoid frequent movement. Avoid excessive heat, dust, vibration and direct sunlight.
Also, provide proper ventilation as the copier emits a small amount of ozone.
Note
1. The recommended environmental range for use is as follows:
• Temperature: 10~30°C/50~86°F
• Humidity: 20~85% RH
2. To ensure optimal operation, allow clearances of at least 80 cm on the left, 80 cm on the right and
10 cm in the rear (refer to the illustration below).
2
To obtain the best possible results, this machine should be used in conjunction with a
dedicated AC power line at the following ratings:
220 - 240 VAC, 50/60 Hz, 1.4 kW or less (e-STUIDO16)
220 - 240 VAC, 50/60 Hz, 1.7 kW or less (e-STUIDO20/25)
110 - 127 VAC, 50/60 Hz, 1.4 kW or less (for Saudi Arabia 100V version only)
Note
1. The use of other appliances or other equipment on the same line as this machine may adversely
affect performance and copy quality.
2. Be sure to use a 3-conductor, grounded wall outlet.
3. In areas where a 2-pin plug is used, the copier must be grounded for safety.
Never ground it to a gas pipe, a water pipe, or any other object not suitable for grounding.
PRECAUTIONS
10 cm
80 cm
80 cm