Filter
Top Products
- 59 -
EO1-11115
MA-186-100 SERIES
(or )
Declaration of Program No.
7 for Hourly Range Table
programming
Hour
(0 to 23)
Repeat for setting next Hourly Ranges (max. 24 hourly ranges)
Z
OFF
X
REG
SET
7
AT/TL
Enter the time that ends the Hourly
Range, in the 24-hour system using the
military time. (The time to start is the time
entered for the preceding Hourly Range.)
@/FOR
→
#/CID
Minute
(00 to 59)
(See NOTES 2, 3)
#/NS
15. Read and Reset Reports
This chapter describes the operation to take each report and its contents. The report function is one of the
most beneficial features of this register. As sales data are entered, the register processes the data into
appropriate totals and counters in the report memory. The reports are not only a form of sales data records
but will also be a valuable guide to a more prosperous future of your store if you fully utilize and analyze
them.
Programming Operations Relating to Reports
Programming Hourly Range Table
The “Hourly Sales Report” is available as part of the report function. However, sales data entered in REG
mode are processed into Hourly Ranges only after programming an Hourly Range Table. If yolu have
started operations on the register without this programming operation performed, the “Hourly Sales Report”
cannot be taken (an error will result on attrempt to take this report). The Hourly Sales Report table must
be programmed in order to obtain Hourly Sales Reports during operations.
Condition: After Hourly Sales Reset
(refer to “NOTE on Condition” on page 15)
Programming Procedure:
Use the MA Key to turn the Control Lock to “SET”.
→ →
→ → →