Filter
Top Products
- 69 -
EO1-11115
MA-186-100 SERIES
Repeat for Bit status changes in all the required Addresses.
Bit Nos. that are set to “SET” status
(max. 8 Bit Nos. combination of 1 to 8)
Address No. (max. 2
digits; 1 to 16)
( )
or
Z
OFF
X
REG
SET
81
@/FOR
→
ST #/CID
AT/TL
#/NS
16. System Option Setting
This operation is provided for your selections of the register’s basic functions according to the market and
your requirements.
Programming Procedure
The System Options are divided into 11 addresses (Addresses 1to 16; Addresses 4, 5, 9, 10, and 12 are
vacant) and each address is further divided into a maximum of 8 bits (Bits 1 to 8). Each address table is
placed on the following pages.
Condition: After Daily Financial Reset (refer to “NOTE on Codition” on page 15)
Programming Procedure:
Use the MA Key to turn the Control Lock to “SET”.
→ →
→ → →
Enter a maximum of eight-digit number composed of Bit Nos. whose status must be set to the “SET” status
in the Address. If there is no Bit No. to be set to the “SET” status, enter “0” for the Address.
Examples) To set Bit 2 only ...............Enter 2.
To set Bits 2 and 3 ...........Enter 23.
To set all the Bits .............Enter 12345678.
To reset all the Bits ..........Enter 0.
To change any Bit in an address, enter the Address No. and enter all the SET Bit Nos. again. If a Bit No.
is not included in the SET Bit Nos., the Bit will be RESET.