Filter
Top Products
4 Replacement Procedures
4.5 Optical Drive Module
Removing the Optical Drive Module
To remove the optical drive module, you need to remove the HDD unit first. Follow the steps
below:
1. Turn the computer upside down.
2. Remove one M2.5x5 screw securing the optical drive module into place.
3. Slide the optical drive module from the bay, if necessary inserting your finger through the
HDD slot and pushing it out.
Figure 4-7 Removing the optical drive module
Installing the Optical Drive Module
To install a device in the optical drive module bay, follow the steps below and refer to the figure
in the preceding section.
1. Slide the device into the optical drive module bay.
2. Use one M2.5x5 screw to secure it in position.
4-12 Satellite P30 Series Maintenance Manual