Filter
Top Products
Error! Style not defined. Error! Style not defined. 4 Replacement Procedures
Installing the ODD Bay Module
Install the ODD bay module according to the following procedures.
1. Place the ODD bay module in the correct position and slide it in.
2. Push it in until it meets the end.
3. Secure the ODD bay module with one M2x8 screw.
Disassembling the ODD Drive
NOTE: Do not disassemble the ODD drive when it is working normally. Disassemble or
replace the ODD drive only if it fails.
Disassemble the ODD drive according to the following procedures and Figure 4.7.
1. Remove two M2x3 screws.
2. Remove the bracket.
M2x3*2
Figure 4.7 Removing the bracket from the ODD drive
Satellite L500 Maintenance Manual 4-17