Filter
Top Products
User’s Manual 3-26
PORTÉGÉ/TECRA R700 Series
4. Turn the computer upside down and remove the battery pack (refer to
Replacing the battery pack section in chapter 6, Power and Power-Up
Modes, if required).
5. Loosen the two screws securing the memory module cover in place -
please note that the screws are attached to the cover in order to prevent
them from being lost.
6. Slide your fingernail or a thin object under the cover and lift it off.
Figure 3-8 Removing the memory module cover
7. Align the notch of the memory module with that of the memory slot and
gently insert the module into the slot at about a 30 degree angle before
holding it down until the latches on either side snap into place.
Use a point size 0 Phillips screwdriver.
1. Screws 2. Memory module cover
2
1