Filter
Top Products
stations on the list, click “Delete All” to
remove all of them.
* Please click on the Apply Changes button or the Reset button to save/reset the configuration.
3.4.8 WDS Settings
Wireless Distribution System (WDS) mode uses wireless media to connect to other wireless access
points. Another term for this feature is wireless point to point or point to multi-point bridging. Wireless
access points using WDS mode must be configured to use the same channel number, wireless security
type, and wireless security key. Add other WDS enabled wireless access points using their device MAC
addresses. This feature is only available when using WDS, AP+WDS, Mesh, or AP+Mesh modes located
under Wireless > Basic Settings. To use WDS, you will require at least 2 or more wireless access points
that support WDS. Note: WDS is not a wireless standard and connectivity may or may not be estab-
lished between different wireless access point devices that support this feature. It is recommended to
use the same device model when using this feature.
Items
Information
MAC Address &
Comment
Fill in the MAC address that you wish to
control, and give a definition to it.
(MAC Address Format: xxxxxxxxxxxx)
Data Rate
The transmit limitation of data packets of this
wireless AP. The wireless AP will use the highest
possible selected transmission rate to transmit
the data packets.
Current WDS AP List
Lists the WDS Settings you have added before.
Click on the list to change configuration. To
Delete the station on the list, mark the check
box in the select item and click the “Delete
Selected”. If you want to delete all stations on
the list, click “Delete All” to remove all of them.
* Please click on the Apply Changes button or the Reset button to save/reset the configuration.