Filter
Top Products
*Note: The following factors may affect the powerline network’s connection quality:
Noise – Generated by appliances that are connected to your electrical system through power outlets that have high
power consumption requirements. (e.g. Microwaves, ovens, blow dryer, iron, dishwasher, etc.) The quality of your
household electrical wiring may also cause additional noise on your electrical system.
Distance – Long lengths of electrical wiring through your electrical system between connected powerline adapters.
LED
Color
Sequen
ce
Definition
PWR (Power)
Green
Solid
Device powered On
N/A
Off
Device powered Off
PL (Powerline)
Note: LED color
indicates the strength
and quality of the
powerline connection
through the electrical
system
Green
Solid
Powerline Connected (Connection Quality is Best)
Blinking
Syncing or Powerline Data Transmitting/Receiving (Connection Quality is
Best)
Amber
Solid
Powerline Connected (Connection Quality is Better)
Blinking
Powerline Data Transmitting/Receiving (Connection Quality is Better)
Red
Solid
Powerline Connected (Connection Quality is Good)
Blinking
Powerline Data Transmitting/Receiving (Connection Quality is Good)
N/A
Off
Powerline is not synced or connected
ETH
(Ethernet Port)
Green
Solid
10/20 Mbps, 100/200Mbps, or 1000/2000Mbps (Half/Full
Duplex) Connected
Blinking
10/20Mbps, 100/200Mbps, or 1000/2000Mbps (Half/Full Duplex) Data
Transmitting/Receiving
N/A
Off
Port Disconnected/No Ethernet Link
WIFI
(Wireless)
Green
Blinking
Wireless is on or enabled / Wireless Data Transmission
N/A
Off
Wireless is off or disabled
WPS
(WiFi Protected Setup)
Green
Blinking
WPS is activated
N/A
Off
WPS is not activated or disabled
Button
Action
Function
Sync
Push/Hold for 2 sec
Initiate Sync/Connection and generate random network name/key on first
adapter (PWR LED will start blinking)
Match network name/key on secondary or additional adapter and connect to
first adapter. (PWR LED will start blinking)
Note: The secondary or additional powerline adapter’s Sync button must also
be pushed within 2 minutes (120 sec) of pushing the Sync button of the first
adapter in order to establish connectivity.
Push/Hold for 10 sec
Erases the network name/key (All LEDs will turn off and turn back on)
WPS
Push/Hold for 3 sec
Activates Wi-Fi Protected Setup (WPS)
Reset
Push/Hold for 1 sec
Reset to Powerline factory defaults only (All LEDs will turn off and turn back on,
PL LED will blink Amber)
Note: Will reset to the factory default private network name “HomePlugAV”.
This will not reset Wireless Access Point settings and the settings will remain
intact.
Push/Hold for 5 sec
Reset to Wireless Access Point factory defaults only (All LEDs will turn off and
turn back on)
Note: This will not reset Powerline settings and the settings will remain intact.