TRENDnet TPL310AP Network Hardware User Manual


 
Wireless
Modulation
OFDM with BPSK, QPSK, 16QAM, and 64QAM
Access Point Modes
Access Point (AP)
Access Point (AP) Client (wireless adapter)
Wireless Distribution System (WDS)
Wireless Distribution System (WDS) with Access Point (AP)
Mesh
Mesh with Access Point (AP)
Repeater (using AP mode only)
Frequency Band
2.412GHz ~ 2.472GHz
Data Rate***
802.11b: 1,2,5.5, and 11Mbps
802.11g: 6,9,12,18,24,36,48 and 54Mbps
802.11n: up to 300 Mbps
Security
64/128-Bit WEP (HEX & ASCII), WPA/WPA2 RADIUS, WPA/WPA2-
PSK
Antenna
2 x 2dBi internal printed dipole antennas
Channel
2.4GHz: 1~11 (FCC), 1~13 (ETSI)
Output Power
16dBm typically @ 802.11b
14dBm typically @ 802.11g
13dBm typically @ 802.11n
Receiver Sensitivity
802.11n Typical -68 dBm
802.11g Typical -73 dBm
802.11b Typical -84 dBm
* Maximum of 16 adapters (nodes) recommended for streaming video across your network. Additional
adapters may decrease performance.
** 200Mbps is the maximum theoretical Powerline data rate. Actual throughput will vary depending
on environment.
***Maximum wireless signal rates are referenced from IEEE 802.11 theoretical specifications. Actual
data throughput and coverage will vary depending on interference, network traffic, building materials
and other conditions.
**** Networked Powerline devices need to be plugged into power outlets that are on the same elec-
trical system.
*****It is not recommended to use this product on electrical systems that use AFCI circuit breakers or
plugged into GFI protected outlets as this may cause performance degradation or loss in connectivity.