Filter
Top Products
Series 600 POS Keyboard 31
Table 3. Local Mode programming Function Codes and Default Settings
FUNCTION
CODE
PARAMETER DEFAULT
SETTING
(XXh = Hex
Code in
ASCII)
REMARKS
12 MSR Track 1,3 Suffix ?<CR>
(3Fh,ODh) for
both format 1
and 3
Used to send suffixes after the magnetic
card data.
13 MSR Track 3 Account
Separator
: (3Ah) for
format 3
Used to send an account separator on the
magnetic card data.
14 MSR Track 2 Prefix ; (3Bh) for
format 2
Used to send a prefix before magnetic card
data.
15 MSR Track 2 Field Separator = (3Dh) for
format 2
Used to send a field separator between
fields of magnetic card data.
16 MSR Track 2 Suffix ?<CR>
(3Fh,0Dh) for
format 2
Used to send a suffix after the magnetic
card data.
17 MSR Bad Read Track 1,3 M1!<CR>
(4Dh,31h,
21h,0Dh)
Used to send a key sequence to the host
computer upon a bad magnetic card read.
18 MSR Bad Read Track 2 M2!<CR>
(4Dh,32h,
21h,0Dh)
Used to send a key sequence to the host
computer upon a bad magnetic card read.
19 MSR Sending Send any
track (0)
Used to send MSR data if one or both
tracks are good. 0 = send any track;
1 = send only if both tracks are good.
20 RS232 Port 0 Baud Rate 9600 Baud
Rate
Used to select a baud rate for Port 0. Baud
rates available are: 300, 600, 1200, 2400,
4800, 9600, 19200, 38400, and 57600.
21 RS232 Port 0 Stop Bits 2 stop bits Used to select number of stop bits (1 or 2)
used with Port 0.
22 RS232 Port 0 Parity No parity Used to select parity used with Port 0.
Selections available are; no parity, odd
parity, or even parity.
23 RS232 Port 0 handshaking Both Used to select method of handshaking
used with Port 0. Selections available are:
none, CTS/RTS, XON/XOFF or both.
24 RS232 Port 0 Word Length 8 bits Used to change the word length, 7 or 8
bits, of the data at Port 0.
25 RS232 port 0 Prefix None Used to place a prefix before the packet of
data before it is sent out of the keyboard
Main Port. (This function is inactive if port
0 is the main port.)
26 RS232 port 0 Suffix (<CR> (0Dh) Used to place a suffix after the packet of
data before it is sent out of the keyboard
Main Port. (This function is inactive if port
0 is the main port.)
Table 3. Local Mode programming Function Codes and Default Settings