Filter
Top Products
Series 600 POS Keyboard 43
Table 5. Remote Programming Mode Commands
OP CODE
(HEX)
MNEMONIC/DESCRIPTION COMMAND/ACKNOWLEDGEMENT
A2 SNDDLY
Determines rate of delay in milliseconds
for sending macros. This command used
when interfacing with slow systems.
COMMAND: A2CxDx<CR>
A2 = Op Code
Cx = hex value for low nibble
Dx = hex value for high nibble
Range = 00 - FF; Where 00 is no delay
and each increment in
count equals 10 mS
<CR> = terminate command (0D hex)
ACKNOWLEDGEMENT: NONE
A3 COMMP
Communications setup for selecting ports,
baud rate, word length, stop bits, parity,
and method of handshaking.
COMMAND: A3Pbbbbbwsph<CR>
A3 = Op Code
P = destination port for load
bbbbb = baud rate
W = word length 7 or 8 bits
s = number of stop bits 1 or 2
p = parity odd, even, or none
h = handshaking
<CR> = terminate command (0D hex)
Port:
0 = main; 1 = AUX
Baud rate:
00300, 00600, 01200,
02400, 04800, 09600,
19200, 38400, 57600
Word length:
7 or 8
Stop bits:
1 or 2
Parity:
O = odd, E = even, N = none
Handshaking:
H = CTS/RTS, S = XON/XOFF,
B = both, N = none
ACKNOWLEDGEMENT: NONE