Uniden BC246T Scanner User Manual


 
40
Basic Operation
Basic Operation
Turning On the Scanner and
Setting the Squelch
Note: Make sure the scanner's antenna is connected
before you turn it on.
1. Turn Sql fully counterclockwise.
2. Press and hold for about 2 seconds to turn on the
scanner, then turn Vol clockwise until you hear a hiss-
ing sound.
3. Turn Sql clockwise until the hissing stops.
Scanning Systems
To begin scanning programmed systems, press Scan.
The BC246T scans all unlocked systems in all activated
quick-key groups.
Notes:
If no systems are programmed, or all systems are
locked out, an error message appears. Program a
system or select a system to scan.
When scanning multiple systems, the BC246T scans
systems according to the assigned quick key. Sys-
tems assigned to quick key 1 are scanned first, then
2, 3, 4, etc. Systems not assigned to a quick key are
scanned last. Within a quick key, systems are
scanned in the order they were assigned.
Within a system, channels are scanned according to
the assigned channel group, with the same priority as
described above for systems.
The BC246T scans a system for the duration you set
using the System Hold Time option (see “Setting the
System Hold Time” on Page 63). For trunked sys-
tems, the scanner moves to the next system after the
hold time expires, the current transmission ends, and
the channel delay expires. Conventional systems
operate similarly, but all unlocked channels are
scanned at least one time regardless of the hold time
setting.
Basic Operation