Filter
Top Products
36
Mounting Using the Optional DIN-E Sleeve
If you are unsure about how to install your scanner in your vehicle using the
optional DIN-E sleeve, consult your automobile manufacturer, dealer, or a qualified
installer. Before installing, confirm that your scanner fits in the desired mounting
area and you have all the necessary materials to complete the task. Your scanner
requires a 2 x 7-1/8 x 5-5/16 inch (50 x 180 x 135 mm) mounting area.
Allow an additional 2-3/8 inch (60mm) space behind the unit for connectors and
wires.
To purchase the DIN-E sleeve and included Removal Keys, visit
http://www.uniden.com/store/ and order part number, DIN-0001.
1. Remove the bracket if it is attached.
2. Remove the four Philips screws from four small tabs on the rear of the case
that secure the outer metal case and pull off the case (toward the rear) with
care.
3. Install the DIN sleeve into the opening in your dashboard, lip facing out.
4. Push out the top and bottom tabs to hold the sleeve firmly in place.
5. Before inserting the scanner in the sleeve, attach the cable from the previously
mounted antenna. Attach the DC Power leads. RED goes to a positive (+)
Opening in dash
DIN E sleeve
BCT15 with outer
case removed