Filter
Top Products
46
10. [EYES] Key
• Press to select (enter) data value or a menu selection.
• Press to edit channel data in Scan or Scan Hold modes.
Note: does not apply to BearTracker system.
• Press to capture and store a frequency in Search, Search Hold, Close Call,
Close Call Hold, WX Scan, and WX Scan Hold modes.
• Press to switch to the Edit Menu for a current Tone-Out.
• Press to switch to Review Location mode for GPS operations.
11. [SCAN/SEARCH] Key
• Press to resume scanning while monitoring a channel in Scan Hold mode.
• Press to switch to Scan mode from any mode except Scan Hold, or GPS
mode.
• Press to enable a scan screen from GPS mode.
12. [HOLD/RESUME] Key
• Press to enable a Hold while in the following modes: Scan, Search, Close Call
Only, and WX Scan.
• Press again to toggle to scan mode from a hold.
Note that an error tone sounds in Close Call Only mode if a signal has not yet
been acquired.
13. [MENU] Key
Press then use the Scroll Control to step to various menu listings for option
settings.
14. BNC Antenna Connector
Connect an appropriate outdoor antenna or push on the supplied indoor antenna.
15. External Speaker Jack
Use an mini (
1
/8-inch 3.5mm) audio plug to connect an external amplified speaker
for enhanced listening in noisy environments.
16. 9-Pin Serial Connector for GPS or PC connection
Using the cable from the GPS, connect a compatible unit here. Using a standard
serial cable and possibly a gender changer or null modem adapter, connect a PC
serial port here.