Filter
Top Products
67
Programming General Settings
Setting the Serial Port Speed
Use this setting to control the data rate used for the front and back panel serial
ports. You typically set the front port to match the speed used to communicate with
your PC (default 115200 bps) and the back port to the speed used to communicate
with an attached GPS device (default 4800 bps). Note that the back port is male.
You may need a gender changer and a null modem adapter to use a typical DB9
serial cable from the rear port.
[MENU] Settings F
Set Serial Port F
Set Baud Rate F
Set Front Port or Set Rear Port F
For Serial Port Speed (Baud Rate), you may select from
4800 bps
9600 bps
19200 bps
38400 bps
57600 bps
115200 bps
Off
Displaying Scanner Information
Viewing Memory Used
[MENU] Settings F
See Scanner Info F
% Memory Used F
The scanner displays the percent of memory that is used, as well as the number
and percent of systems, sites, and channels that are created. Press any key to
return to the previous menu.
Setting the BearTracker Options
Set Hold Time
This is the time that the scanner remains on a transmission while scanning a
BearTracker system until it begins to scan a new system.