Filter
Top Products
2:SCAN OPTION
1:CONVENTIONAL
Choose the channel number. The following options
are available for the selected channel only.
Repeat using a different channel number, if
necessary.
1:FREQUENCY
Allows you to edit or enter a frequency in
each channel you select.
Also you can set an alphanumeric text tag for
each programmed frequency.
2:DELAY
The delay for all programmed channels is
2 seconds. At the end of any transmission
the scanner will remain on the frequency for
2 seconds before resuming scanning.
This will allow you to catch most replies.
3:TONE DATA
You can set a CTCSS (analog) or DCS
(digital) subaudible tone for a frequency.
To do so you must have the SQ Mode in the
System Menu set to Tone SQ. You can also
program a subaudible tone easily by pressing
the E key in Scan Hold mode after
programming a frequency. This will bring up
the Tone Data menu without having to
navigate the Menu. By doing this you will
receive all transmissions on the frequency,
regardless of the subaudible tone, except the
one which you have locked. Any transmissions
with that tone will not be received.
4:BEEP ALERT
You can set a Beep Alert on a per-channel
basis to alert you when specific frequencies
are active. For example, you may wish to be
alerted anytime a mutual aid fire frequency
is active. With Beep Alert, you will hear three
beeps at the start of each transmission that
you have flagged as such. You will also
notice that as you scroll pass the flagged
channel(s), you will hear three beeps.
5:ATTENUATOR
The UBC3300XLT comes with an RF
Attenuation feature. If you are near an
unusually strong signal source, the signal
may overload the scanner. The scanner may
stop repeatedly on that signal and miss other
transmissions.
19
UBC3300XLT OM 5/14/04 3:29 PM Page 19