Filter
Top Products
Restoring a Locked-out Channel
1. Press HOLD/MAN.
2. Select a locked out channel.
a. Enter the channel number using
the keypad.
b. Then press HOLD/MAN again.
3. Press L/O to unlock the channel.
The L/O icon disappears.
Restoring All Locked-out Channels
You can restore all locked-out channels in a bank only when a
bank is selected for scan. If you have deselected a bank and
you want to restore all of its locked-out channels using the
steps below, you must press SCAN and then enter the
number of the bank on your keypad.
1. Press HOLD/MAN.
Note: You must be in Hold mode before restoring all locked-
out channels.
2. Press and hold L/O for about 2 seconds.
You will hear two beeps when all the channels have been
restored.
Priority Scan
When Priority Scan is turned ON, your scanner checks the
priority channel in the banks you selected every 2 seconds for
activity. If a signal is present on the priority channel, your
scanner monitors the channel until the transmission ends,
then resumes normal scanning. You can designate one
channel in each bank as a Priority Channel. By default, the
first channel in each bank is the Priority Channel, but you can
change this.
To activate Priority Scan (in either the Hold or Scan Mode):
1. Press PRI to select PRIORITY ON.
Note: If you have locked out the priority
channel, ERROR appears when
you select Priority mode.
2. Press PRI to select PRIORITY
OFF to deactivate Priority Scan.
34
PRIORITY ON
C 010
1240.0000 FM
ERROR
PRI CH LOCKOUT
HOLD/
MAN
SCAN
CH/
FRQ
MENU/BACK
L/O
.
SELECT
REVERSE
TRUNK
RSM
E
SEARCH
AIR/STEP
UBC3300XLT OM 5/14/04 3:29 PM Page 34