Filter
Top Products
'-
Setup
The UBC 2500XL T comes with a rechargeable Nickel-Cadmium
Battery Pack. When fully charged, this Battery Pack will
supply up to 5 hours of dependable use.
Before using the UBC 2500XL T for the first time, or whenever
the LOW BATTERYIndicator appears on the LCD display, you
should fully charge the Battery Pack.
Note: When the Battery Pack is Iow, the Low Battery
Indicator will start to blink. After about 10 minutes, the
scanner will shut itself off to prevent the battery from becoming
completely discharged.
Before charging, you must first install the Battery Pack
according to the steps below.
Installing the Battery Pack
1. Turn the On-OffNolume Control OFF.
I
2. Slide the pack ontothe bottom of the scanner until it
clicks.
D
~
Charging the Battery Pack
1. Plug the AC Adaptor ICharger (AAD-2500U) into the
Charging Jack located on the back of the Battery Pack.
WARNING! Use only the supplied AC Adaptor/
Charger. Any other AC adaptor or external power plug
having over-voltage or reversed polarity can cause
overheating or damage to the circuitry.
Plug the AC Adaptor /Charger into a standard AC outlet.
2.
13
=I
~
-.
;;::
r
-- -..
-' - ~