Filter
Top Products
Scann ing
1. Turn on the power, or press [SCAN] to start scanning.
Note: When the scanner is turned on, itis automati-
cally in Scan
Mode.
The indicators for the selected banks (1 through 20)
appear on the display. The indicator of the bank
currently being monitored flashes.
While the UBC 2500XL T is scanning, the "SCAN"
message moves across the display. Scanning stops
on any active channel automatically and displays its
frequency, except those channels programmed with
"UO" (Lock Out). Scanning resumes automatically after
the channel becomes inactive, unless DELAY is
activated.
Deselect any bank(s) from being scanned by entering
the number of the bank.
The deselected bank indicator(s) disappear from the
display, and its channels will not be scanned. This
procedure helps to speed up the scanning cycle.
Note: One bank must always remain active. You
cannot deactivate all20 banks at the same
time.
2.
Note: When you turn off the scanner and turn it back
on, the previous bank selections
will remain in effect.
To restore any bank for scanning, just enter its number again.
(The bank indicator will appear on the display.)
To stop scanning any time, press [MANUAL]. When you
press [MANUAL] to stop scanning, you are out of Scan
Mode. The scanner remains on the displayed channel, and
only the bank indicator for that channel appears. If you press
[MANUAL] again, you will step up a channel. If you press
[LMT], you will step down a channel. Press and hold either
key to rapidly step through the channels.
Note: You do not skip a locked out ("UG'? channel using
any of these keys.
To start scanning again, press [SCAN].
To directly access a specific channel:
1. Press [MANUAL].
2.
Enter the channel number using the numeric keys.
3.
Press[MANUAL] again.
23
-L
~
""""
:;:
~ ~1
-"'"'..-. --.....-........
=
I
I
I
..----
i
I
\
I
I
!
,