Filter
Top Products
.-.---
Care and Maintenance
Replacing the Rechargeable Battery Pack
When it is time to install a new Battery Pack, use only the one
made for this scanner. Any other type of battery may damage
yourunit.
To replace the BatteryPack:
1. Removethe BeltClipby liftingthe tab and carefully
slidingitupwardand out.
2. Removethe BatteryPack by pressing in and slidingit
down and off.
3.
Install the new Battery Pack by sliding the pack onto the
bottom of the scanner until it clicks.
Replace the Belt Cljp.
i
I
!
i
I
I
I
i
\
!
\
4.
Note: Be sure to recharge the Battery Pack before using
the scanner.
Battery Maintenance
Most rechargeable batteries typically suffer from "memory
effect"whichoccurs graduallyovertime, shortening the usable
time of the Battery Packwhen it isfully charged. After 2 to 3
months of use, when the Battery Pack holds a charge for a
somewhat shorter period than when first used, follow these
steps:
1. Leave the scanner on untilthe Battery Pack is drained.
(See the Low Battery Indicator description inthe
"Controls and Indicators"sectionfor more information.)
2. Rechargethe Battery Packfor 14 to 16 hours to ensure
a full charge.
3. After the Battery Pack is fully recharged, you may need
to reprogram the channels.
I
General Use
. Turn the scanner off before removingthe Battery Pack.
. Always write down the programmed frequencies in the
event of memory loss. If memory is lost, simply
reprogram each channel.
. Always press each keypad button firmly untilyou hear
the entry tone for that key entry.
1 .-
-~-
-~=
====-
_I
--........-.....
I
I
I
29