Filter
Top Products
--
6.
Press [E] to store the entry.
. If the frequency is already stored in another
channel, the other channel will appear on the
display. To resolve the conflict, just enter another
frequency for the cu"ently selected channel.
(Later, we'll discuss how to delete a stored
frequency.)
. Any frequency already stored in a channel will
automatically be replaced by the new one.
. "Error" appears on the display if an e"or is made
during programming, or if the frequency is out of
range. To clear the error, enter a valid channel or
frequency number.
To program another channel, repeat the above procedures.
B. ProgrammingWith the Rotary Tuner
To program a channel using the Rotary Tuner:
1. If the UBC 2500XLT is scanning, press [MANUAL] to
stop scanning.
2. Select a channel to be programmed by turning the
Rotary Tuner to displaythe channel. (Rotate the control
clockwiseto step up a channel, or counterclockwise to
step down a channel.)
Note: If theChanneVFrequency/LockSelector[CIFIL] .
is set to ilL"(lock), turn the control to "C" to enable
channel selection using the Rotary Tuner.
3. Turn the Channel/Frequency/LockSelector to "F"to
enable frequency selection.
4. Select a frequencyto be stored by turning the Rotary
Tunerto display the frequency. (Rotate the control
clockwiseto step up a frequency, or counterclockwise
to step down a frequency.)
Note: Whenyou rotate the Rotary Tuner, the channel
selection flashes on the display. This means that the
frequency displayed is not programmed in that channel.
5. To store the displayed frequency into
the current
channel, continue with Step 6
-OR-
To store the displayed frequency into another
selected channel,
skip to Step 7
-OR-
I
To store the displayed frequency into another bank's
open (empty) channel, skip to Step 10.
17
=I
=-=-====
---""""
=-=--[
-.-.-
"-
'.
-..-.----
!
i
I
I
.1