Filter
Top Products
--~-------
Setting Up Priority Channels
When you assign "priority" to a bank channel, you designate
one bank channel as your most important channel.
During scanning the UBC 2500XL T works like a "dual watch"
function. It starts "sampling" or keeping track of the activity on
the Priority Channel while listening to other channels. Every 2
seconds, the scanner checks the Priority Channel for activity.
If a signal is present, the Priority Channel will be monitored
until the transmission ends, and scanning resumes. If DELAY
is activated, scanning resumes after 2 seconds.
Note: The Priority feature is also active in Manual,
Search and WX Modes.
Each bank comes with one programmable Priority Channel
(the lowest channel in each bank). You can reassign Priority
Channels to any bank channel if the displayed Channel
Number is 200 or less (Banks 1 through 10). In multi-Priority
Channel operation, the lower channel number has higher
priority .
Note: Priority settings are not erased whenyou turn off the
scanner, or after a power failure.
To set up a Priority Channel:
1. FIrstprogram your most importantfrequency into a
bank channel.
2. Press and hold [PAl] for morethan 2.5 seconds.
A "P" appears on the display to indicatethe designated
channel.
Note:
Any previously assigned Priority Channel within
the same bank is automatically deselected.
I
27
==c
=-====
----
"-
=-
..
I
I
, -q
-