Filter
Top Products
--~- ~----.---
~ramming With SEARCH
'ch feature enables you to rapidly search for active
jes within the specified band limits. When an
Ig frequency is found, you can store it into a channel
t procedure below.
ress [MANUAL] to stop scanning.
Jse the numeric keypad to enter the lower limit and
Ipper limit of the band to be searched. (See "Technical
3pecifications" for a list of search bands.)
Note: When you first use the scanner, you must set
the search limits before activatingSEARCH. Other-
wise, when you try to start SEARCH, error tones are
emitted and "Error" appears on the display.
Example: Set search limitsof 137.000to 144.000
MHz.
FIrst enter the lower limit by pressing:
[1] [3] [7] [.] [0] [0] [0]
Press[LMT].
Then enter the upper limit by pressing:
[1] [4] [4] [.] [0] [0] [0]
Press[LMT].
The search limits of the selected band are now set, and
remain in effect even when you turn off the scanner.
3.
Press [SRC] to start the search.
Note: During the search, you can manually change the
step increment, if desired. To change the step, press
[STP]one time foreach selection: 5 kHz, 12.5kHz,
25 kHz, or 50 kHz, or press [.] twice to reset to default.
4. When Search stops on an interesting frequency, press
[HLD] to stay on that frequency.
Note: Ifyou press [HLD] again, you step up a
frequency. Ifyou press [LMT], you step down a
frequency. Press and hold either key to rapidly step
through the frequencies.
19
- Jf
- ~-
I'