Filter
Top Products
,,----------
"" '"'.".
"-
"
--
5. To store the displayedfrequency into:
(a) the current channel
(b) another selected channel
(c) another bank's open (empty) channel
Please refer to Step 5 of the previous section. The
procedures are the same.
To leave the Search Mode, press [MANUAL] or [SCAN].
D. Programming With AUTO STORE
The Auto Store feature automaticallystores all active
frequencies into open (empty) channels of specified bank(s).
To use AUTO STORE:
1. Press [MANUAL] to stop scanning.
2.
Use the numeric keypad to set the lower limit and upper
limit of the band to be searched. (See "Technical
Specifications" for a list of search bands.)
Note: When you first use the scanner, you must set
the search limits before activating AUTO STORE.
Otherwise, when you try to start
AUTOSTORE,
errortones are emitted and "Error" appears on
the display.
Example: Set search limits of 137.000 to 144.000
MHz.
Firstenter the lower limit by pressing:
[1] [3] [7] [.] [0] [0] [0]
Press[LMT].
Then enter the upper limit by pressing:
[1] [4] [4] [.] [0] [0] [0]
Press [LMT].
3.
The search limits of the selected band are now set, and
remain in effect even when you turn off the scanner.
Note: During AUTO STORE, you can manually
change the step increment, if desired. To change the
step, press [STP] one time for each selection: 5 kHz,
12.5 kHz, 25 kHz, or 50 kHz, or press [.] twice to reset
to default.
Press [AUTO] to activate AUTO STORE.
All bank numbers begin flashing, and "AUTO" appears
on the display.
20
-
_.~ ~.
.,"~"~="~'""."'"