Filter
Top Products
78
LAN
The LAN page gives you settings and information about the Jetpack's network. The LAN menu
contains the following sections:
• IPv4
• IP address — The IP address for the Jetpack.
• Subnet mask — The subnet mask network setting for the Jetpack. The default value
255.255.255.0 is standard for small (class "C") networks. If you change the LAN IP Address,
ensure you use the correct Subnet Mask for the IP address range containing the LAN IP
address.
• MAC address — The Media Access Controller (MAC) or physical address for the Jetpack.
• Turn On DHCP server — The Turn On DHCP Server checkbox enables or disables the DHCP
Server feature. Normally this should be left turned on.
• Start DHCP address range at — The start range of IP addresses reserved for use by the
Jetpack's DHCP server table.
• DHCP address range — The current range of IP addresses reserved for use by Jetpack's
DHCP server table. If a device with a static IP address wants to connect to MiFi6620L's
network, the static IP should be outside of the DHCP address range. Most devices do not
have a static IP.
• DHCP lease time — Use todetermine how often connected devices must renew the IP
address assigned to them by the DHCP server. Normally this is left at the default value,
but if you have special requirements you can change the value.
• IPv6
• Enable IPv6 — The Enable IPv6 checkbox turns ON/OFF the IPv6 feature.
• Link-Local address — Displays the local address when IPv6 is turned on.
• Save Changes — Use to activate and save new settings.