Filter
Top Products
Chapter 3 Basic Setting and Operation
2 Registering and deleting E-mail addresses
Enter the e-mail address onto "Add e-mail
address" and click Set button.
To check the registered addresses, click
Check/Delete sub menu tab. The address-
es are listed as the figure on the right.
Up to 10 E-mail addresses can be registered.
To delete the registered addresses, check the
address you want to delete and click Delete
button.
Check / Delete
If the projector sends an alert message due to the abnormality on the projector but the SMTP serv-
er is down in some other reason, the message will not be sent. In this case, the message "Unable to
connect to server." will be displayed on the setting page. To clear this message, set up SMTP server
address again.
To use the E-Mail function, it must be set the DNS address on the Network setting page correctly.
You cannot use this E-mail function if the DNS server and SMTP server cannot be used in your net-
work environment.
The projector does not send message to the address set in "Administrator address" text box. If you
want to send e-mails to the administrator address, enter the administrator address into "Add address"
text box.
1 Setting SMTP server and administrator address
Enter the server name or IP address of the
SMTP server*
1
, the port number of the
SMTP server and administrator address and
click Set button. The administrator address
is set to "Reply-To" address of the message
sent from the projector.
*1 The SMTP server is a server for sending e-mail. Please contact your network administrator to
have this SMTP server address.
3 Setting SMTP authentication
Set the SMTP authentication concerned
and click Set button. Please contact your
network administrator in details.