Filter
Top Products
60
Index
Contents
60
Index
Contents
Interactive pen display
REPLACING THE PEN TIP
The pen tip (nib) will wear with normal use. Excessive pressure will cause it to wear sooner. If your pen
display has a coated surface a worn nib may cause damage. To avoid this, periodic tip replacement is
recommended.
When the nib gets too short or develops a sharp edge, replace it with one of the extra nibs that came with
the pen.
Important: When not in use, place the pen in the pen storage compartment or lay it flat on your desk.
Take care not to damage the pen nib when inserting or removing the pen from the storage
compartment. To maintain the sensitivity of your pen, do not store the tool in a container where it
will rest on its tip.
Clasp the old nib with a Wacom nib
extraction tool, pair of tweezers,
needle-nosed pliers, or similar
instrument and pull it straight out of
the pen.
Slide the end of the new nib straight
into the barrel of the pen. Firmly push
the nib until it stops. The new nib will
slide into the correct position.
Warning
Choking hazard. Prevent children from swallowing the pen nib or side switch. The pen nib or side switch may
accidentally be pulled out if children are biting on them.
Replace the pen nib when it gets too short, or less than 1 mm (0.04 inch).