Filter
Top Products
2
Installation and
Configuration
Introduction
The Ethernet/RS-232 Interface is usually installed at the factory. Your
local distributor or service center can also install the interface,
especially for use in a previously-purchased supply already on site. You
must then configure the Interface-enhanced supply for your system
using the “Basic Setup Procedure - Ethernet” on page 2–10, or the
“Basic Setup Procedure - RS-232” on page 2–11.
To use this product, you must have the following equipment:
• a Xantrex XFR DC output power supply
• computer-based communications software package
TM-XR9B-01XN.book Page 1 Monday, April 19, 2004 9:00 AM