Filter
Top Products
24
NOS Selection
TCP/IP Protocol Configuration
To view or change the settings of the Device's TCP/IP Protocol Configuration, perform the following steps:
To access the TCP/IP Protocol Settings at the Device
1. Press the Log In / Out button on the Control Panel.
2. Press the "1" key on the numeric keypad five consecutive times. (This is the factory default
"password.")
3. Press Enter on the touch screen.
4. Press the Machine Status button on the Control Panel.
5. Press the Tools tab.
6. Press Connectivity & Network Setup.
7. Press Protocol Settings.
8. When the Protocol Settings menu displays, note that with the exception of selection one (Ethernet
Rated Speed), the remaining selections are specific to TCP/IP address settings. Choose your setting
of interest by pressing the numbered, horizontal selection line on the touch screen. Note that the
current status of each setting is shown on the applicable line. After pressing a selection line, to access
available settings press the Change Settings button in the lower right corner of the touch screen.