Filter
Top Products
Operational Safety
Safety Notes ❖ vii
Operational Safety
Your Xerox printer and supplies were designed and tested
to meet strict safety requirements. These include safety
agency examination, approval, and compliance with
established environmental standards.
Your attention to the following safety guidelines will help
to ensure the continued safe operation of your printer.
• Use the material and supplies specifically designed for
your printer. The use of unsuitable materials may result
in poor performance and possibly a hazardous
situation.
• Follow all warnings and instructions marked on, or
supplied with, the printer, options and supplies.
• Place the printer in a dust free area where the
temperature range is 50° F to 90° F (10° C to 32° C) and
the relative humidity is 15% to 85%.
• Choose a location for the printer allowing sufficient
space around the printer for operation and
maintenance. The minimum recommended room size
is 10 cubic meters/353 cubic ft. or approximately 8 ft. x
8 ft. x 8 ft. / 242 cm x 242 cm x 242 cm.
• Place the printer in an area where there is adequate
space for ventilation and servicing. The recommended
minimal spacing for operations is 10 in. (25 cm) behind
the printer, 10 in. (25 cm) on either side of the printer,
and 24 in. (61 cm) in front of the printer. For Service,
the suggested spacing is 4 ft. x 4 ft. (1.2m x 1.2m).