Filter
Top Products
The pressure applied by the toggle assembly may need to be increased or
reduced when different thicknesses or widths of media are used in the
printer.
NOTE: Before increasing toggle pressure to achieve darker print darkness,
perform the print quality adjustments.
Refer to Figure 23. Turn the two knurled toggle pressure adjust knobs (a)
on top of the toggle assembly to adjust the pressure. Turning clockwise will
increase the pressure, and turning counterclockwise will decrease the
pressure.
Always use the lowest toggle pressure necessary to provide the desired print
darkness on the label.
NOTE: When using media narrower than 4.5" wide (full media width),
reduce the pressure on the right hand toggle until print quality is affected,
then increase pressure just to the point where good print quality is achieved.
This reduces the wear on those areas of the printhead and the platen where
ribbon and media are not present. (For very narrow media, zero pressure
from the right toggle may be required.)
32 S400 & S600 User’s Guide
a
Right
Toggle
Figure 23
40