Filter
Top Products
Media Rest Position Adjustment
This procedure sets the end-of-label position relative to the Tear-Off plate
or cutter. Adjust this if your label is not being torn or cut at the correct
point.
1. Briefly press the MODE button twice. The PAUSE and POSITION
LEDs turn on.
2. Press UP (FEED) or DOWN (CANCEL) to adjust the current setting.
3. Briefly press the MODE button twice. The MODE LEDs will flash on and
off to indicate that the settings have been saved in memory.
4. Press PAUSE to exit the pause mode. The PAUSE LED turns off.
Top of the Label Position Adjustment
This procedure positions the printing on the label relative to the top edge of
the label. Adjust this if your printing is too close or too far away from the
top or bottom edge of the label.
1. Briefly press the MODE button twice, then press and hold it for about
five seconds until the lights change. The PAUSE, DARKEN, and
CALIBRATE LEDs turn on.
2. Press UP (FEED) or DOWN (CANCEL) to adjust the current setting.
3. Briefly press the MODE button twice. The MODE LEDs will flash on
and off to indicate that the settings have been saved in memory.
4. Press PAUSE to exit the pause mode. The PAUSE LED turns off.
Media Sensor Position Adjustment
This procedure is covered in Getting Ready to Print.
Ribbon Supply Spindle Adjustment
This procedure is covered in Getting Ready to Print.
S400 & S600 User’s Guide 33
41