Filter
Top Products
Charging the Battery
Refer to Figure 3 (your battery charger may look slightly different than the
ones illustrated).
If you are using a 120 VAC battery charger:
1. With the battery installed in the printer, insert the connector of the
battery charger into the receptacle on the side of the printer.
2. Plug the battery charger into an appropriate 120 VAC electrical outlet.
3. The battery charging LED will briefly flash and then stay on. When
the battery is fully charged (approximately one hour for the standard
battery; two hours for the extended life battery), the light will go off.
4. You may either remove the battery charger from the printer or leave it
connected for a continuous maintenance charge.
If you are using a universal battery charger:
1. With the battery installed in the printer, insert the connector of the
battery charger into the receptacle on the side of the printer.
2. Make sure the supplied power cord is inserted in the battery charger.
3. Plug the other end of the cord into an appropriate AC electrical outlet.
4
Power
Cord Plug
Varies by
Country
120 VAC
Charger
Universal
Charger
Figure 3