Filter
Top Products
9. The tear bar should not be installed in the printer. If it is, gently lift the
tab on the bar to get it over the protrusion on the door (reverse the
procedureshowninFigure7).Then,pullthebaroutoftheprinter.
NOTE:Whennotinuse,thetearbarmaybestoredontheinside
ofthemediaaccessdoor.RefertoFigure9.Withthelipofthebar
facingtheinsideofthedoor,simplyalignthenotchesofthebar
withthetabsonthedoor.Pressandslidethebartowardthe
door’shingedend.
If you’re using direct thermal media, continue on with step 10.
However, if you’re using thermal transfer media, you must also install
aribboncartridge.Proceedto“LoadingtheRibbon”inthischapter.
11
Tear Bar
Notch
Tear Bar
Notch
Door
Tab
Door
Tab
Figure 9