Filter
Top Products
Feed Button Modes
39
Power Off Mode (Communications Diagnostics Mode)
With the printer power off, press and hold the Feed button while you turn on the
power.Theprinterprintsoutalistingofitscurrentconfiguration(seeFigure27).
After printing the label, the printer will automatically enter a diagnostic mode in
whichtheprinterprintsoutaliteralrepresentation(seeFigure28)ofalldata
subsequently received.
Power On Modes
With the printer power on, printhead closed, and Error LED off, press and hold the
Feed button for several seconds. The Error LED will flash a number of times in
sequence. The explanation at the right (Action) shows what happens when you
release the key after the specific number of flashes.
Flash
Sequence Action
* A configuration label prints.
*
**
The media sensor calibrates and a media sensor profile prints (see
CalibrationandFigure25).
*
**
***
Theserialcommunicationparametersareresetto9600baud,8bitsper
character, no parity, 1 stop bit, and XON/XOFF.
*
**
***
****
Resets the factory defaults, auto calibrates, and saves settings into
memory.
*
**
***
****
*****
The print width is calibrating. While the Error LED rapidly flashes, a
series of stacking rectangles prints on the label. When the rectangle
prints to the outer edges of the label, press and release the Feed
button. The label width and current communication parameters will be
saved into memory.
If the Feed button is held down for six flashes and quickly released, the printer will
ignore the button. For additional information, refer to the maintenance manual.