Filter
Top Products
9. Refer to Figure 7. If it’s not already in place, install the tear bar in the
media access door. Gently lift the tab on the bar to move it over the
protrusion on the door. Make sure the lip of the bar (inset, Figure 7)
faces out of the printer.
If you’re using direct thermal media, continue on with step 10.
However, if you’re using thermal transfer media, you must also install
a ribbon cartridge. Proceed to “Loading the Ribbon” in this chapter.
10. Close the printhead and the top cover.
8
Tab
Lip
Protrusion
Figure 7