Filter
Top Products
10. Close the printhead and the top cover.
11. Swing up the media access door, ensuring that the media liner is
threaded through the wide slot in the media access door (refer to
Figure 10).
12. Lift to hook the top of the media access door over the top cover.
13. Push in the bottom of the media access door to close.
14. Turn on the printer or press the Feed button if the printer is already on.
NOTES: To ensure optimal print quality, make sure that the
backing material is flush against the peel bar (as shown in
Figure 10). If it starts to “loop” away from the peel bar, gently
pull down on the backing material.
With certain types of media, it may be necessary to reduce the
print speed to 1.5” (38.1 mm) per second to produce consistent
peel operation. Consult your authorized Zebra reseller for advice
and information.
12
Label
Wide Slot
Backing
Material
Figure 10