Filter
Top Products
4. The battery charging LED will briefly flash and then stay on. When
the battery is fully charged (approximately one hour for the standard
battery; two hours for the extended life battery), the light will go off.
5. You may either remove the battery charger from the printer or leave it
connected for a continuous maintenance charge.
Loading the Media
You can operate this printer in one of two different modes: Tear-Off or
Peel-Off. Tear-Off mode allows you to tear off each label (or a strip of
labels) after it is printed. In Peel-Off mode, the backing material is peeled
away from the label as it is printed. After you remove this label, the next
one is printed.
Tear-Off Mode
NOTE: If ribbon is loaded (PT400 only), remove the ribbon
cartridge before loading the media.
1. Refer to Figure 4. Raise the media access door by lifting at the notch
until it unhooks from the top cover.
5
Top Cover
Notch
Media
Access
Door
Figure 4