Filter
Top Products
802.11n Wireless Print Server User Manual
77
Print Port Related Problems
Printing data failure may be caused by a loose connection of the print server to the
USB port of the printer. Check to see if any of the pins on the USB connector are
damaged. In addition, check the cable connection. If the pins are damaged,
contact your dealer for a replacement connector.
Windows 2000/XP Troubleshooting
Multi-Segment LAN Environment Installation (through the Network Print Port)
If your print server and Windows 2000/XP/2003/Vista/7 are located on two
different segments, and your Windows NT server is used as the router/gateway
you will need to implement the following procedures in order for your print server
to function properly:
Add the RIP for NWLink IPX/SPX compatible transport. See RIP for NWLink
IPX/SPX compatible transport Installation Procedure later in this section.
Add the frame type 802.2 for both Ethernet adapters. See Multi-Segment
Frame Type 802.2 Installation later in this section.
RIP for NWLink IPX/SPX compatible transport Installation Procedure
1. From your Windows NT server that is used as a router, select Start from the
bottom left hand corner of the screen.
2. Select Settings.
3. Select Control Panel.
4. Double-click the Network icon.
5. Select Services.
6. Select Add.
7. In the Select Network Service box, select the RIP for NWLink IPX/SPX
compatible transport. Click OK.
8. Follows the directions on the screen.
9. Done.