Zonet Technology ZPW4000 Printer User Manual


 
802.11n Wireless Print Server User Manual
89
Question C
The upgrading process indication bar stops and does not seem to proceed again
while upgrading the print server.
Possible Explanation
There might be a network problem. This causes the upgrading procedure to fail.
Solutions
1. Check the network cabling, especially from the workstation running the
PSAdmin to the print server unit.
2. Run the PSAdmin and upgrade the print server again.
Question D
The Status LED light keeps blinking after POST.
Possible explanation and solution
The last upgrade process was not completed. The print server must be upgraded
again by using the PSAdmin. Please see Chapter 3 for details.
Question E
The PSAdmin reports “Create Print server Error”, “Create Printer Error”, or
“Create Print Queue Error” while using Auto Setup.
Possible Explanation
The print server name, the printer name, or the print queue name you specified in
the Auto Setup dialogue box contains a space.
Solution
Check to see if there is a space in the print server name, the printer name, or the
queue name. Type in a new name without a space between two characters or
replace a space by a dash (-) or an underscore (_).