Filter
Top Products
Chapter 10 Interface
ZyWALL USG 100/200 Series User’s Guide
242
Figure 169 Network > Interface > WLAN > Add (WEP Security)
The following table describes the WEP-related wireless LAN security labels in this screen.
See Table 67 on page 238 for information on the 802.1x fields.
10.9.3 WLAN Add/Edit Screen: WPA-PSK/WPA2-PSK Security
WPA-PSK or WPA2-PSK security has all of the WLAN interface’s users share the same
password (pre-shared key). To configure and enable WPA-PSK or WPA2-PSK security, click
Network > Interface > WLAN > Add (or Edit) to open the WLAN Edit screen. Select
WPA-PSK or WPA2-PSK as the Security Type. The following screen shows the security
fields.
Figure 170 Network > Interface > WLAN > Add (WPA-PSK/WPA2-PSK Security)
Table 68 Network > Interface > WLAN > Add (WEP Security)
LABEL DESCRIPTION
WEP Encryption WEP (Wired Equivalent Privacy) provides data encryption to prevent unauthorized
wireless stations from accessing data transmitted over the wireless network.
Select 64-bit WEP or 128-bit WEP to enable data encryption.
Key 1 to Key 4 If you chose 64-bit WEP in the WEP Encryption field, then enter any 5 characters
(ASCII string) or 10 hexadecimal characters ("0-9", "A-F") preceded by 0x for each
key.
If you chose 128-bit WEP in the WEP Encryption field, then enter 13 characters
(ASCII string) or 26 hexadecimal characters ("0-9", "A-F") preceded by 0x for each
key.
There are four data encryption keys to secure your data from eavesdropping by
unauthorized wireless users. The values for the keys must be set up exactly the
same on the access points as they are on the wireless stations.