Filter
Top Products
Appendix A Log Descriptions
ZyWALL USG 100/200 Series User’s Guide
783
[SA] : Tunnel [%s]
Phase 1 authentication
method mismatch
%s is the tunnel name. When negotiating Phase-1, the authentication
method did not match.
[SA] : Tunnel [%s]
Phase 1 encryption
algorithm mismatch
%s is the tunnel name. When negotiating Phase-1, the encryption
algorithm did not match.
[SA] : Tunnel [%s]
Phase 1 invalid
protocol
%s is the tunnel name. When negotiating Phase-1, the packet was not
a ISKAMP packet in the protocol field.
[SA] : Tunnel [%s]
Phase 1 invalid
transform
%s is the tunnel name. When negotiating Phase-1, the transform ID
was invalid.
[SA] : Tunnel [%s]
Phase 1 key group
mismatch
%s is the tunnel name. When negotiating Phase-1, the DH group of the
attribute list `attrs' did not match the security policy.
[SA] : Tunnel [%s]
Phase 1 negotiation
mode mismatch
%s is the tunnel name. When negotiating Phase-1, the negotiation
mode did not match.
[SA] : Tunnel [%s]
Phase 2 authentication
algorithm mismatch
%s is the tunnel name. When negotiating Phase-2, the authentication
algorithm did not match.
[SA] : Tunnel [%s]
Phase 2 encapsulation
mismatch
%s is the tunnel name. When negotiating Phase-2, the encapsulation
did not match.
[SA] : Tunnel [%s]
Phase 2 encryption
algorithm mismatch
%s is the tunnel name. When negotiating Phase-2, the encryption
algorithm did not match.
[SA] : Tunnel [%s]
Phase 2 pfs mismatch
%s is the tunnel name. When negotiating Phase-2, the PFS specified
did not match.
[SA] : Tunnel [%s]
Phase 2 pfs
unsupported: %d
%s is the tunnel name. When negotiating Phase-2, this device does
not support the PFS specified.
[SA] : Tunnel [%s]
Phase 2 SA
encapsulation
mismatch
%s is the tunnel name. When negotiating Phase-2, the SA
encapsulation did not match.
[SA] : Tunnel [%s]
Phase 2 SA protocol
mismatch
%s is the tunnel name. When negotiating Phase-2, the SA protocol did
not match.
[SA] : Tunnel [%s] SA
sequence size mismatch
%s is the tunnel name. When negotiating Phase-2, the SA sequence
size did not match.
[XCHG] exchange type
is not IP, AGGR, or
INFO
This device is the responder and this is the initiator’s first packet, but
exchange type is not IP, AGGR, or INFO and the packet is ignored.
Cannot resolve My IP
Addr %s for Tunnel
[%s]
1st %s is my ip address. 2nd %s is the tunnel name. When selecting a
matched proposal in phase-1, the engine could not get My-IP address.
Table 289 IKE Logs (continued)
LOG MESSAGE DESCRIPTION